Frameguard

Colour:  White

Roll Size:  Widths 24mm to 1000mm in 15 metre lengths

Adhesive:  Acrylic Solvent

Description:  A 2mm UV Stabilised, non-woven needle punched oven bonded PET fibre felt bonded to a 140 micron solvent acrylic adhesive with a 105 gsm white bleached PE coated kraft release liner. A high performance solvent acrylic, with excellent tack and initial adhesion. It is plasticiser and UV resistant, giving good ageing properties and good all round weatherability, with high & low temperature resistance

Application: For Greenhouses/Hothouses in the protection of PE sheeting stretched over frames. The felt insulates the PE from the metal hoops and also minimises friction and abrasion of the PE, thereby extending the life of the structure. The PET felt is specially developed for maximum UV stability.

Technical Details:

Surface Preparation:  The surface on which the tape is to be used must be clean, dry and free from grease and dust. Remember that pressure sensitive adhesive must be applied with the maximum possible pressure in order to achieve maximum adhesion levels. The recommended application temperature is between 15ºC and 25ºC.

Storage:  Tapes stored below the minimum application temperature will require warming up to that level before use. Up to 24 hours may be required for this to take place.

Note:  The above figures represent average values. Actual figures can vary. The selection and application of a tape is the responsibility of the buyer. Tape should be stored at room temperature and should not be exposed to sunlight. We reserve the right to make changes without notice to our products and specifications.